Brother MFC-J6730DW - Page 190

3-67
Confidential
(3) Remove the Flat core from the Lower cover and pull out the Panel flat cable from
the Flat core.
(4) Remove the two screws (TAPTITE CUP B M3x10) and remove the Tilt cover from
the Tilt holder.
Fig. 3-64
(5) Tilt the Control panel ASSY in the direction of the arrow.
(6) Push the Tilt ratch in the direction of the arrow until clicks.
Fig. 3-65
TAPTITE CUP B M3x10
Tilt cover
Flat core
Main PCB harness hold R
Panel flat cable
Tilt holder
3a
3b
4
5
Tilt ratch
Control panel ASSY
6
Tilt ratch
A view
<A view>
6