What to do if my Bruker Laboratory Equipment cannot deliver parahydrogen in continuous flow mode when ready?
If your Bruker Laboratory Equipment cannot deliver parahydrogen in continuous flow mode, execute a warm-up, then a purge, because it may be caused by a conversion chamber blockage. If the problem persists, contact Bruker service, because the outlet valve may be malfunctioning.
What to do if there is a low coolant level in my Bruker Laboratory Equipment?
If you have a low coolant level, refill coolant reservoir.
General| Category | Laboratory Equipment |
|---|---|
| Type | High Pressure Homogenizer |
| Magnetic Field Strength | Not Applicable |
| Proton Frequency | Not Applicable |
| Flow Rate | Data unavailable |
| Temperature Range | Data unavailable |
Details the manual's purpose, intended users, and essential reading requirements for safe operation.
Outlines Bruker's commitment to product improvement, specifications, and customer feedback.
Explains safety symbols (DANGER, WARNING, CAUTION, NOTICE) and their significance.
Lists and briefly describes the primary components of the BPHG 90 instrument housed in a single cabinet.
Explains the conversion of ortho- to parahydrogen at low temperatures using a catalyst.
Stipulates that installation and commissioning must be performed by authorized Bruker personnel.
Specifies conditions under which the manufacturer accepts no liability for damages, including improper use.
States the manual is protected by copyright and intended solely for internal use.
Notes that warranty terms are included in the manufacturer's Terms and Conditions.
Provides information on contacting customer service for technical support and product feedback.
Presents the product's Certificate of Compliance and related certification details.
Covers general safety, awareness of high voltages, and verifying power disconnection before work.
Defines the device's specific purpose and warns against any deviations as improper use.
Details the owner's obligations for ensuring safe operation, compliance with regulations, and personnel training.
Specifies qualifications, training, and prohibitions for personnel operating the device.
Mandates the use of personal protective equipment as defined by the laboratory head.
Highlights the supervisor's responsibility for maintaining the correct placement of warning labels.
Covers risks from electrical power, mechanical hazards, magnetic fields, and general workplace dangers.
Explains electrical voltage and danger spot warning signs found in the work area.
Warns that using non-approved spare parts invalidates the manufacturer's guarantee.
Provides physical specifications including weight, length, width, and height of the generator.
Details electrical specifications (voltage, power, frequency) and gas inlet/outlet parameters.
Specifies environmental parameters such as temperature range, humidity, and operating altitude.
Explains the information presented on the device's rating plate, including manufacturer and electrical ratings.
Lists standard accessories and optional hydrogen supply/storage kits included with the generator.
Covers packaging standards, materials used, and protection against damage during transport.
Explains common handling and orientation symbols found on the packaging material.
Provides instructions for checking the delivery for completeness and transport damage.
Outlines recommended conditions for storing packages to maintain product integrity.
Covers location, hydrogen supply requirements, and general preparations before installation.
Details steps for connecting hydrogen supply, exhaust, Ethernet, USB, and mains power.
Covers initial power-up, system checks, status LEDs, and entering standby mode.
Explains access to adjustable parameters and operating information for system configuration.
Explains the procedure to remove air and contaminants before initial cooling.
Initiates the cool-down procedure, checks cryostat vacuum, and starts the cryocooler.
Details continuous flow and batch delivery modes for parahydrogen output.
Provides recommended procedures for safe shutdown, including a warm-up phase.
Lists common problems, their potential causes, and recommended remedies for the BPHG 90.
Overview of yearly maintenance by Bruker Service, including sensor checks, pump, coolant, and cryocooler.
Covers user tasks like cleaning, coolant circuit maintenance, and fuse replacement.
Lists part numbers and descriptions for commonly used spare parts.
Outlines the steps for safely shutting down and dismantling the BPHG 90.
Provides guidelines for the proper recycling and disposal of dismantled components.
Provides the address, phone, fax, and email for Bruker BioSpin customer support.
To Next Page
