Burkert 8228 ELEMENT - Knowing The Parameters Menu; Transferring Data from One Device to Another; Setting the Date and Time

45
Operating and commissioning
Type 8228
9.11 Knowing the Parameters menu
9.11.1 Transferring data from one device to another
See chap. 9.9 to access the Parameters menu.
This function is only possible with a display module with software version V2.
→ On the device, check the software version in the menu "Info -> Software -> Main".
• The software version of the display module is displayed when the display module is powered up.
• Function "DOWNLOAD" is only present if an "UPLOAD" has been successfully carried out.
• Never interrupt a data transfer else the device could be damaged.
The compensation curve determined with the function TEACH SPECIAL (see chap. 9.12.4) cannot be
transferred to another device.
SystemParam
Up/Download Download
Upload
This is
when the
device is be-
ing parame-
tered............
....................
This is
when the
device is be-
ing parame-
tered............
....................
Downl. Yes/No
Upload Yes/No
The following data can be transferred from a device to another device of the same type:
• user set data of the PARAM menu (except the date, the time, the contrast and brightness levels for the display),
• user set data of the DIAGNOSTIC menu,
• the TDS factor set in the menu Calib -> Sensor -> Probe -> Cell cst TDS,
• the correction factor set in the menu Calib -> Sensor -> Probe -> K-fitting,
• the periodicity of calibrations set in the menu Calib -> Sensor -> Probe -> Calib interval,
• the access codes to the menus.
DOWNLOAD: transfer the data previously uploaded in the display module with the "UPLOAD" function.
The parameters transferred are used by the device as soon as the message “Download OK” is displayed.
UPLOAD: upload data from the device to the display module.
9.11.2 Setting the date and time
See chap. 9.9 to access the Parameters menu.
System Date
Time
Param YYYY/MM/DD
HH:MM
ss
This is
when the
device is be-
ing parame-
tered............
....................
This is
when the
device is be-
ing parame-
tered............
....................
DATE: set the date (input format: year/month/day in the form YYYY/MM/DD)
TIME: set the time (input format: hours:minutes
secondes
)
English