70
Accessories and spare parts
Type 8228
11 ACCESSORIES AND SPARE PARTS
CAUTION
Risk of injury and/or damage caused by the use of unsuitable parts.
Incorrect accessories may cause injuries and damage the device and the surrounding area.
▶ Use only original accessories and original replacement parts from Bürkert.
Accessory Order code
Display module 559 168
Set with 2 opaque covers, with seals:
- 1 screw cover with 1 EPDM seal
- 1 quarter turn closing cover with 1 silicone seal
560 948
Set with 2 transparent covers, with seals:
- 1 screw cover with 1 EPDM seal
- 1 quarter turn closing cover with 1 silicone seal
561 843
Calibration solution, 300 ml, 706 µS/cm 440 018
Calibration solution, 300 ml, 1413 µS/cm 440 019
Calibration solution, 500 ml, 12880 µS/cm 565 741
Calibration solution, 300 ml, 100 mS/cm 440 020
5-pin female M12 connector, to be wired 917 116
5-pin female M12 female connector, moulded on shielded cable (2 m) 438 680
5-pin male M12 connector, to be wired 560 946
5-pin male M12 connector, moulded on shielded cable (2 m) 559 177
Spare part
(only for devices with a G2'' process connection)
Order code
Snap ring
619 205
PC nut for PC housing
619 204
12 PACKAGING, TRANSPORT
NOTE
Damage due to transport
Transport may damage an insufficiently protected device.
▶ Transport the device in shock-resistant packaging and away from humidity and dirt.
▶ Do not expose the device to temperatures that may exceed the admissible storage temperature range.
▶ Protect the electrical interfaces using protective plugs.
English
To Next Page
Loading...
