Cambium Networks ePMP 3000 Series User Manual

CHAPTER 4: USING THE DEVICE
MANAGEMENT INTERFACE
USING THE MENU OPTIONS
PAGE 4-70
Attribute
Meaning
(Subscriber
Module Mode)
MAC Address
(Subscriber
Module Mode)
The MAC address of the visible Access Point.
Frequency Carrier
(MHz)
(Subscriber
Module Mode)
The current operating frequency of the visible Access Point.
Channel
Bandwidth (MHz)
(Subscriber
Module Mode)
The current operating channel bandwidth of the visible Access Point.
RSSI (dBm)
(Subscriber
Module Mode)
The current measured Received Signal Strength Indicator at the Access Point.
SNR (dB)
(Subscriber
Module Mode)
The current measured Signal-to-Noise Ratio of the Subscriber Module to Access
Point link.
Registration State
(Subscriber
Module Mode)
The indication of the result of the Subscriber Module device network entry
attempt:
Successful: Subscriber Module registration is successful
Failed: Out of Range: The Subscriber Module is out of the
configured maximum range (Max Range parameter)
Failed: Capacity limit reached at Access Point: The Access Point is no longer
allowing Subscriber Module network entry due to capacity reached
Failed: No Allocation on Access Point: The Subscriber Module to Access Point
handshaking failed due to a misconfigured pre-shared key between the Subscriber
Module and Access Point
Failed: SW Version Incompatibility: The version of software resident on the
Access Point is older than the software version on the Subscriber Module
Failed: PTP Mode: ACL Policy: The Access Point is configured with PTP Access
set to MAC Limited
PTP MAC Address field
Failed: Other: The Access Point does not have the required available memory to
allow network entry

Cambium Networks ePMP 3000 Series Specifications

General

Brand	Cambium Networks
Model	ePMP 3000 Series
Category	Wireless Access Point
Language	English