2. The Power Lamp is lit when the printer finishes starting up, and the printer is now in Standby.
The printer will not go into Standby in the following situations. Take the appropriate action.
•
The Top Cover is open
Close the Top Cover.
•
The Ink Tank Cover is open
Close the Ink Tank Cover.
•
The Printhead is not installed
see "Replacing the Printhead." →P.810
•
An Ink Tank is not installed
see "Replacing Ink Tanks." →P.800
•
If ERROR is shown on the Display Screen
see "Error Messages." →P.877
•
The Power Lamp and Message Lamp are not lit (even once), and nothing appears on the Display
Screen
Make sure the printer is plugged in correctly. Check the connection at the plug and electrical outlet.
•
No paper is loaded
Load paper. (See "Loading and Printing on Rolls.") →P.6 (See "Loading and Printing on Sheets.")
→P.9
Important
• Starting the printer when it is connected via the USB cable to a Macintosh computer that is off may cause the
computer to start up at the same time. To prevent this, disconnect the USB cable before starting the printer.
Connecting the printer to the computer via a USB hub may solve this issue.
Basic Printing Workflow
>
Printing procedure
>
Turning the Printer On and Off
iPF655
1
4
To Next Page
Loading...
