Canon imagePROGRAF iPF655 - Initial Settings; Configuring the IP Address on the Printer

Initial Settings
Configuring the IP Address on the Printer ...................................................................................................... 768
Configuring the IP Address Using the Printer Control Panel ...................................................................... 769
Configuring the IP Address Using ARP and PING Commands .................................................................. 770
Configuring TCP/IPv6 Network Settings ......................................................................................................... 771
Configuring the Printer Driver Destination (Windows) .................................................................................... 772
Configuring the Printer Driver Destination (Mac OS X) ................................................................................... 773
Configuring the Printer's TCP/IP Network Settings With RemoteUI ................................................................ 773
Configuring the IP Address on the Printer
You must configure the printer's IP address before using the printer in a TCP/IP network.
The printer's IP address is configured automatically when you install the printer driver following the instructions in the Set-
up Guide.
Configure the IP address by using imagePROGRAF Device Setup Utility, the printer Control Panel, or ARP or PING com-
mands, if the IP address is changed, or if you change the printer connection mode to a network connection. For details on
configuring the IP address, refer to the following topics.
• Configuring the IP Address Using imagePROGRAF Device Setup Utility →P.410 (Windows)
• Configuring the IP Address Using the Printer Control Panel →P.769
• Configuring the IP Address Using ARP and PING Commands →P.770
Important
• If you use a DHCP server for automatic assignment of the printer's IP address, printing may no longer be
possible after the printer is turned off and on. This is because an IP address different from before has been
assigned. Thus, when using DHCP server functions, consult your network administrator and configure the
settings in one of the following ways.
• Configure the setting for dynamic DNS updating
In the printer menu, either set DNS Dync update to On, or activate the setting Enable DNS Dynamic
Update in RemoteUI.
(See "Menu Settings.")
→P.739
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.") →P.773
• Configure the setting for assignment of the same IP address each time the printer starts up
Note
• We recommend configuring the printer's IP address even if you will use the printer in networks other than
TCP/IP networks. Configuring the printer's IP address enables you to use RemoteUI to configure the network
settings and manage the printer with a web browser.
For details on RemoteUI, see "Using RemoteUI." →P.765
Network Setting > Initial Settings >
Configuring the IP Address on the Printer iPF655
10
768