Configuring the Printer's NetWare Network Settings With RemoteUI
Follow the steps below to configure NetWare protocol settings other than the frame type by using RemoteUI.
Note
• For details on RemoteUI, see "Using RemoteUI." →P.765
1. Start the web browser and enter the following URL in the Location (or Address) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon.
3. If a password has been set on the printer, enter the password.
4. Click Network in the Device Manager menu at left to display the Network page.
5. Click Edit in the upper-right corner of the NetWare group to display the Edit NetWare Protocol Settings page.
6. Refer to the NetWare Settings Items table to complete the settings.
NetWare Settings Items
Item Details
Default Set-
ting
Frame Type Specify the type of frame to use in NetWare. Disabled
NCP Burst Mode Activate this setting to use NCP Burst Mode.
This mode supports fast data transfer when printing in queue
server mode. Normally, leave the setting On.
On
Print Application Choose the print service.
The print service selected here is enabled. Multiple print services
cannot be enabled simultaneously.
• Bindery PServer
• RPrinter
• NDS PServer
• NPrinter
NDS
PServer
Packet Signature Select If Requested by Server to use packet signature. If Re-
quested
by Server
Bindery PSer-
ver
File Server
Name
Specify the name of a file server that has a NetWare print server.
(0–47 characters)
—
Print Server
Name
Specify the name of a NetWare print server.
(0–47 characters)
—
Print Server
Password
Set a password for the print server.
(0–20 characters)
—
Polling Interval Specify the interval to confirm jobs. 5
Network Setting
>
NetWare Settings
>
iPF655
Configuring the Printer's NetWare Network Settings With RemoteUI
10
785
To Next Page
Loading...
Need help?
General