Setting Item Description, Instructions
Adjust
Printer
Feed
Priori-
ty
Adj.
Quality
Auto(GenuinePpr) Specify this mode with paper identified in the Paper
Reference Guide.
The printer prints and reads a test pattern for automat-
ic adjustment of the feed amount. (See "Automatic
Banding Adjustment (Adj. Quality).")
→P.688
Auto(OtherPaper) Specify this mode with paper not in the Paper Refer-
ence Guide.
The printer prints and reads a test pattern for automat-
ic adjustment of the feed amount. Note that this func-
tion takes more time and consumes more ink than Au-
to(GenuinePpr). (See "Automatic Banding Adjust-
ment (Adj. Quality).") →P.688
Manual Use this mode with highly transparent media or other
paper for which Auto(GenuinePpr) or Auto(Other-
Paper) cannot be used.
Print a test pattern for adjustment of the feed amount
based on the type of paper. (See "Manual Banding
Adjustment (Adj. Quality).") →P.689
Adjust
Length
Adjust-
ment-
Print
A:High Print a test pattern for particular types of paper to
compensate for paper stretching or shrinkage, after
which you enter the amount of adjustment. (See "Ad-
justing Line Length (Adjust Length).") →P.692
B:Standard/Draft
Chang
e Set-
tings
A:High Displayed when you have selected Feed Priority >
Adj. Priority > Print Length.
Adjustment relative to the amount of stretching or
shrinkage of the current paper.
Enter either the adjustment results from Adjustment-
Print or the discrepancy that you measured (as a per-
centage).
For paper that tends to stretch, increase the feed
amount by choosing a higher adjustment value. For
paper that tends to shrink, decrease the feed amount by
choosing a lower adjustment value.
B:Standard/Draft
Main-
te-
nance
Head Cleaning Clean the Printhead. (See "Cleaning the Printhead.")
→P.809
Choose Head Cleaning A if printing is faint, oddly
colored, or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or
if printing is not improved by Head Cleaning A.
Nozzle Check Print a test pattern to check the nozzles.
Replace P.head When replacing the Printhead, choose Yes and follow
the instructions on the screen. (See "Replacing the
Printhead.") →P.810
Not displayed during a warning message that the re-
maining Maintenance Cartridge capacity is low.
Repl. maint cart When replacing the Maintenance Cartridge, choose
Yes and follow the instructions on the screen. (See
"Replacing the Maintenance Cartridge.")
→P.818
Head Info Indicates information about the printhead.
Control Panel
>
Printer Menu
>
Menu Settings
iPF655
9
744
To Next Page
Loading...
