1- 14
 What’s On the Operation Panel?
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Reading Operation Panel Lamps
The lamps on the operation panel indicate the following
states.
a Data lamp
z Flashing:
The printer is printing, receiving or processing a print
job.
When the printer is not printing, this indicates that a job
has been stopped and the printer is in the pause
mode, the printer is has received data that it cannot
process, or the firmware is being updated.
z Off:
There are no jobs in the printer.
b Message lamp
z On:
A warning is displayed on the operation panel.
z Flashing:
An error has occurred.
z Off:
The printer is operating normally, or the printer is
switched off.
c Roll Media lamp
z On:
Roll media is selected as the paper source.
d Cut Sheet lamp
z On:
Cut sheet is selected as the paper source.
e Online lamp
z On:
The printer is online or the printer is processing a print
job or sleeping.
z Off:
The printer is offline or in pause mode, in menu display
mode, is initializing immediately after power on, or has
been switched off.
Data
Information Power
Offline
Menu
Message
e
a
b
c
d
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
To Next Page
Loading...
Need help?
General