6- 4
îš‹ Responding to Error Messages
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Media Messages
Load Roll Media
Problem1: The printer is waiting for you to load the roll
media.
Solution1: Follow the procedure below set the Media Type
and Media Size settings the same as those for
the roll media. (→ P. 2- 2 6 )
1. Load a roll with media that is the same type
and size as the printer settings.
2. Select the media type.
3. Select length if the media remaining detection
feature for roll media is on.
4. Press the OK button.
Solution2: Hold down the Stop/Eject button for at least 1
second to stop printing.
Remove Roll Media
Problem1: The printer is waiting for you to remove the
ejected roll media.
Solution1: Perform the procedure below to remove the roll.
1. Open the upper cover.
2. Push the release lever to the rear and
remove the roll.
3. Pull the release lever toward you to close it.
4. Raise the upper cover stopper to release the
lock then close the upper cover.
To Next Page
Loading...
Need help?
General