4- 44
îš‹ Adjusting Amount of Media Feed
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
5
Press the [] or [] button to select the
desired setting value then press the OK
button.
If you want to widen the gap between the bands,
enter a number from 1 to 3.
If you want to narrow the gap between the bands,
enter a number from -1 to -3.
The selected setting is prefixed with an equals sign
(=) to denote the current setting.
6
Press the Online button.
The Online lamp lights and the printer is ready to
print.
Note
z The value for the amount of feed adjustment can be
performed during printing. However, if you change the
amount of feed during printing, the print result may be
distorted by about 3 cm immediately after the change.
z Adjust in the plus (+) direction if white stripes are
visible in the output image, or adjust in the minus (−)
direction if dense color stripes are visible.
Fine Tuning
=0
Online
Bk
Data
Information Power
Offline
Menu
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
To Next Page
Loading...
Need help?
General