5- 13
îš‹ TCP/IP Network Settings (Windows, Macintosh, UNIX)
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
5
Press [] or [] to select IP Address, then
press [
].
6
Press [] or [] to change the number
setting of the IP address, then press the OK
button.
7
To enter the IP address allocated for the
printer, press [
] or [] to change the
number, then press [
] or the OK button.
The selected digit increments by 1 every time you
press []. However, at 255 the number rolls up to 0.
The selected digit decrements by 1 every time you
press []. However, at 0 the number rolls up to 255.
Note
z If you press and hold the [] or [] button, the value
increases or decreases in steps of 10
8
Repeat Steps 6 to 7 to enter the IP address
assigned to the printer.
Enter the subnet mask.
9
Press [] once then press [] or [] to
select Subnet Mask then press [
].
10
Press [] or [] to change the number
setting of the subnet mask, then press OK
button.
11
Press [] or [] to set the number of the
subnet mask in use on the network, then
press OK button.
The selected digit increments by 1 every time you
press []. However, at 255 the number rolls up to 0.
The selected digit decrements by 1 every time you
press []. However, at 0 the number rolls up to 255.
12
Repeat Steps 10 to 11 to enter the subnet
mask that the network is using.
Enter the default gateway.
IP Setting
IP Address ↓
IP Address
=0.0.0.0
IP Address
=XXX.0.0.0
IP Address
=XXX.XXX.XXX.XXX
IP Setting
Subnet Mask ↓
Subnet Mask
=0.0.0.0
Subnet Mask
=XXX.0.0.0
Subnet Mask
=255.255.255.0
To Next Page
Loading...
Need help?
General