5- 42
NetWare Settings (Windows)
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
7
For Print Application select the service to
use.
Note
z Here we will show only one service selected and
enabled. More than one service cannot be enabled at
the same time.
8
When using the packet signature settings, for
Packet Signature be sure to select If
Requested by Server.
9
Perform the following settings as required for
the selected service.
z Bindery PServer Selected: Queue Server Mode
(Using a Bindery Print Server)
Enter the file server name into File Server
Name.
For Print Server Name, enter the name of the
print server created in “Setting Up a NetWare
Print Service” (→ P. 5- 3 7 ).
For Print Server Password, enter the print
server password created in “Setting Up a
NetWare Print Service” (→ P.5-37).
Set the Polling Interval. Set the time interval
for the printer to confirm the NetWare print
queue.
z RPrinter Selected: Remote Printer Mode (using a
Bindery Print Server)
For Print Server Name, enter the advertised
name of the print server created in “Setting Up
a NetWare Print Service” (→ P.5-37).
For Printer Number, enter the same printer
number that you entered in “Setting Up a
NetWare Print Service” (→ P.5-37).
To Next Page
Loading...
Need help?
General