Canon iPF9000S - Page 43

Chapter 2 Indexes by Case
2-31
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(★: Reference fault
isolation procedure
or tool)
2909 File read error.
Turn off printer,
wait a while, and
turn it on again.
Invalid files
will be deleted.
HDD file error Restart the
printer.
(The file in error
is deleted, but
the printer will
recover normally
when it is
restarted.)
290A Hardware error.
03130031-290A
Turn off printer,
wait, then
turn on again.
HDD not connected.
HDD was not detected at startup.
Connect the HDD/
Check the
harness.
Replace the HDD.
2918 Power On
Again
Cassette
Sensor
Detectio
n Error
Cassette detection sensor detection failure
(cassette presence/absence sensor)
No cassette has been detected during
cassette pickup.
①Check to see if
the cassette
itself is
properly
loaded.
②Check and
replace sensor
(IO mode).
291A Roll sensor
cannot detect.
Turn on printer
again.
Power On
Again
Roll
Sensor
Detectio
n Error
Roll sensor detection failure
Could not detect the roll unit.
①Check the roll
unit, and
remove, install
or replace the
roll unit.
②Check IO
mode (roll unit
detection).
291B Hardware error.
03130031-291B
Turn off printer,
wait, then
turn on again.
Power
On
Again
Lift
Motion
Timeout
Lift shift timeout
A lift operation has been executed, but no
sensor has been detected or a sensor has
remained detected.
①Switch off the
printer, then
back on.
②The carriage
cannot travel
to the lift drive
position.
③The lift drive
cam is not
engaged.
④Faulty lift drive
sensor
⑤Faulty lift drive
motor
Go to ★
4027(P3-22).
291D Hardware error.
03130031-291D
Turn off printer,
wait, then
turn on again.
Power
On
Again
Hardware
Err 1
0313003
1-291D
Spur cam sensor detection failure Check the spur
cam sensor in IO
mode.
・If OK, check the
lifter drive
system.
・If NG, replace
the sensor.