Canon iPF9000S - Page 49

Chapter 2 Indexes by Case
2-37
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Wrong paper type.
Check paper type
setting on computer.
Online: Print
Stop: Stop Printing
Wrong paper type
and size. Check
paper type and size
setting on computer.
Online: Print
Stop: Stop Printing
2E16
Wrong paper type
and size. Check
paper type and size
setting in driver.
Online: Print
Stop: Stop Printing
Paper
Mismatch
Prnt:Pres
sOnline
Check
Paper
Press
Online
Paper mismatch (type)
The data type defined in the data and the
type of actually loaded paper do not match.
Following the transmission of data in the
GARO format, all of the following conditions
have been met at the start of printing:
・The paper type that has been set in the job
and the type of actually fed paper do not
match.
・[Stop] has been selected for [Paper
Mismatch Detection].
Check the paper
that is actually
loaded on the
printer and the
driver paper type
setting.
2E17 No cassette
detected.
Check the cassette.
Cassette
Undetecte
d
Check
Cassette
Press
Online
Cassette not installed ①Check to see if
the cassette
itself is
properly
loaded.
②Check and
replace sensor
(IO mode).
2E18 Cannot load.
Press Load/Eject
and reload the
paper.
Remove
paper
Cannot
Feed
Press
↑ Key
Paper not fed as far as the platen Go to ★2E27
(P3-14).
2E19 Cannot load.
Press Load/Eject
and reload the
paper.
Remove
paper
Cannot
Feed
Press
↑ Key
Feeding error
LF out of synchronization for cut sheet
①Refeed the
paper.
②★Go to
2E27(P3-14).
2E1A Cannot load.
Press Load/Eject
and reload the
paper.
Remove
paper
Cannot
Feed
Press
↑ Key
Feeding error
LF out of synchronization for cut sheet
①Refeed the
paper.
②★Go to
2E27(P3-14).
The roll is empty.
Load/Eject:
Change Paper
The roll is empty.
Lift the release
lever and replace
the roll.
The roll is empty.
The roll is empty.
Lift the release
lever and replace
the roll.
2E1B
Out of roll paper.
Push the release
lever back, then
replace the roll.
Roll
Paper
Please
Replace
Paper
Not
Loaded
Press
↑ Key
No roll paper available (trailing edge of roll
paper detected)
・Trailing edge of paper has been detected
by paper sensor in a roll paper operation.
・LF out of synchronization on roll paper.
(Detected the spool no longer rotating.)
①Replace the roll
paper.
②Check paper
sensor R (IO
mode).
③Is the paper fed
successfully
(under a
negative load
or any other
influence)?