Canon iPF9000S - Page 66

Troubleshooting Guide
2-54
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(★: Reference fault
isolation procedure
or tool)
4045 ERROR
E196-4045
Call for service.
ERROR
E196-404
5
Call For
Service
Engine EEPROM write error
An EEPROM read/write failure has been
detected in the engine portion of the
firmware.
①Start in
download
mode to
upgrade the
firmware.
②Restart the
printer in
service mode
to clear the
error.
③Replace the
main PCB.
4046 ERROR
E141-4046
Call for service.
ERROR
E141-404
6
Call For
Service
Recovery part revolutions reaching 50,000
cycles or more
Recovery part operations have reached a
predetermined count.
Check the parts
counter and
replace required
parts.
(Replacement of
the parts coming
to the end of their
useful lives is
recommended.)
Initialize the
counter for the
replacement unit
mounted.
The
iPF5000/500/600
have a counter
problem fixed.
Identify the
firmware version
and start in
download mode
to upgrade the
firmware to
Ver.1.13 or later
from any earlier
release.
4047 ERROR
E144-4047
Call for service.
ERROR
E144-404
7
Call For
Service
Supply part count error
Supply part operations have reached a
predetermined count.
Check the parts
counter and
replace the
target unit or
Refresh Service
Kit.
Initialize the parts
counter for the
target unit after
the replacement.
4048 ERROR
E144-4048
Call for service.
ERROR
E144-404
8
Call For
Service
Non-discharging nozzles on initial filling
An unallowable number of non-discharging
nozzles have been detected at the
completion of initial filling.
Go to ★2F2F
(P3-6).
4049 Unknown file.
Check file format.
Turn off printer,
wait a while, then
turn it on again.
Cannot
update
firmware
Power
On
Again
Wrong transfer ROM data model
Files for a different model have been
transferred on firmware update.
①Restart the
printer in
service mode
to clear the
error (this
error won’t
occur when
FUT is used).
②Start in
download
mode to
upgrade the
firmware.
③Replace the
main PCB.