Canon iPF9000S - Page 65

Chapter 2 Indexes by Case
2-53
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(★: Reference fault
isolation procedure
or tool)
4042 Unknown file.
Check file format.
Turn off printer,
wait a while, then
turn it on again.
MIT data transfer failure
Failed to write MIT data on its transmission.
①Execute
“Initialize
Paper Type”
from the
system
settings.
(Note: All
paper
information
will be reset to
its factory
defaults and
additional
Paper
deleted.)
②Upgrade the
firmware in
download
mode.
③Replace the
main PCB.
4042 ERROR
E196-4042
Call for service.
ERROR
E196-404
2
Call For
Service
Flash write error
Failed to write flash ROM on execution of
the firmware update.
①Start in
download
mode to
upgrade the
firmware.
②Restart the
printer in
service mode
to clear the
error.
③Replace the
main PCB.
4043 ERROR
E196-4043
Call for service.
ERROR
E196-404
3
Call For
Service
Firmware update failure error
Failed to allocate a work area on RAM on
firmware update.
①Start in
download
mode to
upgrade the
firmware.
②Restart the
printer in
service mode
to clear the
error.
③Replace the
main PCB.
4044 ERROR
E196-4044
Call for service.
ERROR
E196-404
4
Call For
Service
EEPROM size error
Size information about the firmware data
transmitted on firmware update and the size
of actually transmitted data do not match.
①Start in
download
mode to
upgrade the
firmware.
②Restart the
printer in
service mode
to clear the
error.
③Check the
firmware
transfer
environment
(IF changes,
PC).
④Replace the
main PCB.