Capron A72 User Manual

Appliances
110 Capron - 3141417 - 03/20 - EHG-0021-02EN
10
The hot-water heater with the boiler can be operated with various energy
sources.
 Turn rotary push button (Fig. 110,6) until the menu symbol operating
mode (Fig. 111,3) flashes.
 Press rotary push button.
 Turn rotary push button until the desired operating mode is displayed:
 Gas operation
 Electrical operation, output level 1 (900 W)
 Electrical operation, output level 2 (1800 W)
 Gas operation and electrical operation output level 1 (900 W)
 Gas operation and electrical operation output level 2 (1800 W)
 Press the rotary push button to save the set operating mode. To revert
to the original setting: Press back button (Fig. 110,7).
 230 V electrical operation is only possible when the vehicle is connected
to the 230 V power supply.
 With output level 1 (900 W), the current consumption is 3.9 A. With out-
put level 2 (1800 W), the current consumption is 7.8 A.
 Turn rotary push button (Fig. 110,6) until the fan menu symbol
(Fig. 111,4) flashes.
 Press rotary push button.
 Turn rotary push button until the required value is displayed:
 OFF: Fan is switched off.
 VENT: Air circulation
 ECO: Low fan setting
 HIGH: High fan setting
 BOOST: Fast room heating. Boost is available if the current room
temperature is at least 10 °C below the selected room temperature.
 Press rotary push button to save the value set. If you do not wish to
change the value originally set: Press back button (Fig. 110,7).
 Turn rotary push button (Fig. 110,6) until the timer menu symbol
(Fig. 111,9) flashes.
 Press rotary push button. The start time is displayed and the hour dis-
play flashes.
 Turn rotary push button until the hour of the selected start time is dis-
played.
 Press rotary push button. The minute display flashes.
 Turn rotary push button until the minute of the selected start time is dis-
played.
 Press rotary push button.
 Proceed in the same way to set the switch-off time, the required room
temperature, the hot water setting and the fan setting.
 Press rotary push button. The timer is activated. The timer symbol
(Fig. 111,9) flashes when the timer is programmed and active.
Operatin
g
modes
Selecting operating mode:
Setting the fan:
Setting the timer:

Capron A72 Specifications

General

Brand	Capron
Model	A72
Category	Caravans
Language	English