76
Factory Service Department | Phone: 1-866-784-6900 | Fax: 1-919-516-8710
Start-Up Documentation
START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN AIR
BALANCED AND WITH THE HEAT ON (Warranty will be void without completion of this form)
Job Information
Unit Information
Refer to the start-up procedure in this manual to complete this section.
*If measured amps exceed the FLA rating on the nameplate, fan RPM must be reduced to decrease the
measured amps below the nameplate FLA rating.
Job Name
Address
City
State
Zip
Phone Number
Fax Number
Contact
Purchase Date
Quantity of Fan(s)
Size of Fan(s)
Service Company
Address
City
State
Zip
Phone Number
Fax Number
Contact
Start-up Date
Name Plate and Unit Information
Model Number
Serial Number
Input Voltage
Input Frequency
Input Phase
Input FLA
Input HP
Field Measure Information
Motor Voltage
Motor Amperage*
RPM
To Previous Page
Loading...
