5.
On the non-Cardo headset, activate Bluetooth pairing mode (see the non- Cardo headset user manual).
6.
The device confirms that pairing has succeeded and the LED flashes purple for 2 seconds.
To pair your SMARTH with non-Cardo headsets through SmartSet:
1.
Confirm your SMARTH is in Bluetooth intercom mode:
■
Normal battery state - LED flashes blue slowly.
■
Low battery state - LED flashes red slowly.
■
Charging - LED flashes purple slowly.
2.
Open SmartSet and tap .
3.
Tap Bluetooth.
4.
Tap Add for the required channel. and follow the on screen menus.
To pair your SMARTH with non- Cardo headsets through the headset voice-assisted menu:
1.
Confirm your SMARTH is in Bluetooth intercom mode:
■
Normal battery state - LED flashes blue slowly.
■
Low battery state - LED flashes red slowly.
■
Charging - LED flashes purple slowly.
2.
Tap ~ and ~Volume Up twice.
3.
When the voice-assisted menu reaches "Advanced Features", tap ~ or use VOX.
4.
When the voice-assisted menu reaches your required option ("Pair Mobile phone to Channel 1", "Pair Mobile
phone to Channel 2", or "Pair GPS to Channel 1 ), tap ~ or use VOX.
To cancel the pairing process, press ~Phone until the LED stops flashing.
If pairing is not completed within 2 minutes, the headset automatically returns to Standby.
To reset all Bluetooth intercom pairing, while in Bluetooth intercom pairing mode, press ~ and ~Phone for 2
seconds.
If your SMARTH is not in Bluetooth intercom mode, press ~Intercom and ~Audio. For more information see,
"Switching to Bluetooth Intercom" on page 31.
To reset all Bluetooth intercom pairing, tap Delete all.
When using voice-assisted menus, you can only pair through Channel B.
If your SMARTH is not in Bluetooth intercom mode, press ~Intercom and ~Audio. For more information see,
"Switching to Bluetooth Intercom" on page 31.
To reset all Bluetooth intercom pairing, select the menu option "Reset Channel A & B Pairing".
To Next Page
Loading...
