3.4
Basic Functions
To turn the volume up for current audio source:
●
Tap ~Volume Up.
With each tap, a louder tone is played on the speaker.
To turn the volume down for current audio source:
●
Tap ~Volume Down.
With each tap, a quieter tone is played on the speaker.
To mute the microphone completely and lower the speaker volume for the current state:
●
Tap ~Volume Up and ~Volume Down.
The red LED comes on for 2 seconds and a descending tone is played on the speaker.
3.5
Pairing Your Headset to Bluetooth Devices
Your SMARTH has two Bluetooth channels for connection to mobile phones, GPS devices and music players with A2DP.
To connect your SMARTH to a Bluetooth device, you must first pair them. Once paired, they automatically recognize
each other whenever they are within range (10m / 33ft).
3.5.1
Pairing through the Headset Buttons
To pair Bluetooth channel 1 to a device:
1.
Enable Bluetooth on the device.
2.
Press ~Phone for 5 seconds.
3.
Search for Bluetooth devices on your device as described in your device's instructions.
4.
After a few seconds the device lists your SMARTH. Select it.
5.
If prompted for a PIN or Passkey, enter 0000 (four zeros).
6.
The device confirms that pairing has succeeded and the LED flashes purple for 2 seconds.
To pair Bluetooth channel 2 to another device:
1.
Enable Bluetooth on the device.
2.
Press ~Audio for 5 seconds.
3.
Tap ~Phone twice until the LED start flashing red and green.
4.
Search for Bluetooth devices on your device as described in your device's instructions.
5.
After a few seconds the device lists your SMARTH. Select it.
6.
If prompted for a PIN or Passkey, enter 0000 (four zeros).
7.
The device confirms that pairing has succeeded and the LED flashes purple for 2 seconds.
You can automatically adjust your volume to reduce noise by using AGC (automatic gain control). AGC adjusts your
volume according to ambient noise and riding speed. You can also adjust AGC sensitivity, see "Configuring Your
SMARTH Basic Settings" on page 18.
If you are pairing more than one device, Cardo recommends that you pair the mobile phone to channel 1, and the
GPS or music player to channel 2.
To Next Page
Loading...
Need help?
General
