Cardo Systems SMARTH - 5.2.3 Streaming Music in DMC intercom Mode; 5.3 Making and Receiving Bluetooth Intercom Calls

- 35 -
SMARTH Manual
5. On the Road
To unmute the DMC group for SMARTH with Cardo headsets through SmartSet:
1. Make sure that your headset is paired to the mobile device on which SmartSet is installed.
2. Open SmartSet and tap the DMC.
3. Tap MUTE GROUP.
To unmute the DMC group for SMARTH with Cardo headsets through the headset voice-assisted menu:
5.2.3 Streaming Music in DMC intercom Mode
5.2.3.1 Background Audio Level and Audio Source Priorities
The SMARTH can stream audio from two connected sources simultaneously, so that you can listen to your music or the
FM radio while holding a DMC intercom conversation. Background Audio Level is automatically disabled during mobile
phone conversations and GPS directions instructions.
By default, Background Audio Level is enabled. See Section 4 - Before You Ride to adjust the settings. If disabled, the
SMARTH automatically determines which audio source to play based on the priority of the connected devices.
Priority
Audio Source
Higher Priority
↑
Lower Priority
Mobile phone 1, GPS device instructions
1
Mobile phone 2, GPS device instructions
1
Intercom (Click-to-Link/DMC and Bluetooth modes) or A2DP music
2
A2DP music or Intercom (Click-to-Link/DMC and Bluetooth modes)
2
FM Radio
1
Phone calls and GPS temporarily mute DMC intercom, but group members remain part of the DMC intercom group.
2
Depends on your A2DP/IC Priority setting, as configured in SmartSet (see "Configuring Your SMARTH through Cardo
SmartSet" on page 17).
5.3 Making and Receiving Bluetooth Intercom Calls
Intercom modes all have the same priority, so ongoing intercom calls will not be interrupted by any other
intercom call.
Bluetooth intercom and Click-to-Link calls have the same priority, so Click-to-Link calls will not interrupt any
Bluetooth intercom call in progress, and vice versa.
In DMC intercom, if no group member is speaking and music is playing, the music volume automatically
increases. When a DMC intercom group member speaks, the music volume automatically reduces.
To make and receive Bluetooth intercom calls, you must first pair the Bluetooth, see "Pairing the Bluetooth
Intercom" on page 11.
During a 3 or 4-way Bluetooth intercom conference call while riders are range (1.2 km / 3,900 ft), riders using
both Bluetooth intercom channels cannot receive phone calls or GPS instructions while the call is in progress.
For more information see, "Making and Receiving Bluetooth Intercom Calls" above.
If DMC intercom is active while making or receiving a phone call, DMC intercom automatically resumes after
the call ends.