■
Charging - LED flashes purple slowly.
2.
Open SmartSet and tap .
3.
Tap Bluetooth
4.
Tap Add for the required channel. and follow the on screen menus.
To pair your SMARTH with Cardo headsets through the headset voice-assisted menu:
1.
Confirm your SMARTH is in Bluetooth intercom mode:
■
Normal battery state - LED flashes blue slowly.
■
Low battery state - LED flashes red slowly.
■
Charging - LED flashes purple slowly.
2.
Tap ~ and ~Volume Up twice.
3.
When the voice-assisted menu reaches "Advanced Features", tap ~ or use VOX.
4.
When the voice-assisted menu reaches your required option ("Pair Intercom A", "Pair Intercom B", or "Pair
Intercom C"), tap ~ or use VOX.
3.6.2
Pairing the Bluetooth Intercom to non-Cardo Headsets
The Cardo gateway enables Cardo headsets to connect to non-Cardo over Bluetooth.
To pair your SMARTH with non- Cardo headsets through the headset buttons:
1.
Confirm your SMARTH is in Bluetooth intercom mode:
■
Normal battery state - LED flashes blue slowly.
■
Low battery state - LED flashes red slowly.
■
Charging - LED flashes purple slowly.
2.
On your headset, press ~ for 5 seconds.
3.
Select the Bluetooth intercom channel you would like to pair:
■
Channel A - do not tap anything (default channel).
■
Channel B - tap ~ twice.
4.
Tap ~Phone to activate the Cardo gateway.
If your SMARTH is not in Bluetooth intercom mode, press ~Intercom and ~Audio. For more information see,
"Switching to Bluetooth Intercom" on page 31.
To reset all Bluetooth intercom pairing, tap Delete all.
If your SMARTH is not in Bluetooth intercom mode, press ~Intercom and ~Audio. For more information see,
"Switching to Bluetooth Intercom" on page 31.
To reset all Bluetooth intercom pairing, select the menu option "Reset Channel A & B Pairing".
If your SMARTH is not in Bluetooth intercom mode, press ~Intercom and ~Audio. For more information see,
"Switching to Bluetooth Intercom" on page 31.
To Next Page
Loading...
Need help?
General
