EasyManua.ls Logo

Cardo Systems SMARTH - 5.3.1 Receiving Bluetooth Intercom Calls

Cardo Systems SMARTH
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 36 -
SMARTH Manual
5. On the Road
To start a Bluetooth intercom call, do one of the following:
To use the headset buttons :
To start a call with rider A or add rider A to a call, tap ~.
To start a call with rider B or add rider B to a call, tap ~ twice.
To start a conference call with riders A and B, press ~ for two seconds.
Use VOX. If you are paired and connected (within range), a Bluetooth intercom call with riders A, B or A+B is
started.
To use SmartSet: On the INTERCOM screen, select the required channel (A, B, or A+B).
To use the headset voice-assisted menu:
a.
Tap ~ and ~Volume Up twice.
b.
When the voice-assisted menu reaches "Call Intercom", tap ~ or use VOX.
To end a Bluetooth intercom call, do one of the following:
To use the headset buttons:
To disconnect rider A, tap ~.
To disconnect rider B, tap ~ twice.
To end all active Bluetooth intercom connections, press ~ for 2 seconds.
If you initiated the Bluetooth intercom call using VOX: remain silent for at least 30 seconds. Any open call is
disconnected.
To use SmartSet: On the INTERCOM screen, select the required channel to disconnect.
5.3.1
Receiving Bluetooth Intercom Calls
If another paired headset calls you via Bluetooth intercom, the call begins instantly.
To receive Bluetooth intercom calls from unpaired headsets, see "Click-To-Link Calls" below.
5.3.2
Bluetooth Intercom Busy Signal
A busy signal is heard when you attempt a Bluetooth intercom call when the other rider is in:
phone call
Bluetooth intercom call with Channels A and B
One+8 intercom call
Click-to-Link call
5.3.3
Click-To-Link Calls
Click-to-Link is a spontaneous way to instantly initiate one-on-one intercom calls with other riders near you, without
being paired.
If a single rider (A or B) is connected, a Bluetooth intercom call is opened to the connected rider.
If riders A and B are connected, a Bluetooth intercom conference call is opened with Riders A and B.
If other Cardo users are nearby, your next Click-to-Link call may randomly connect to any of them.

Other manuals for Cardo Systems SMARTH

Related product manuals