3.
On the preset station you want to edit, click .
4.
Enter the desired FM station's frequency and press Enter.
4.2.4
Upgrading Firmware for New Features
For new features, Cardo may periodically update the SMARTH firmware.
To update the firmware:
1.
Go to http://cardosystems.com/cardo-community/, register and login.
2.
Download the Cardo Updater from the provided links and install it on your computer.
3.
Connect the USB cable Type A plug to your computer USB port. 2.
4.
Connect the USB cable Type B plug to the SMARTH USB port.
4.3
Configuring Your SMARTH through the Headset Voice-Assisted Menus
You can configure your SMARTH using the headset's voice-assisted menu in combination with either headset buttons
or use VOX.
To configure your SMARTH through the voice-assisted menus:
1.
Confirm your SMARTH is in Bluetooth intercom mode:
■
Normal battery state - LED flashes blue slowly.
■
Low battery state - LED flashes red slowly.
■
Charging - LED flashes purple slowly.
2.
Tap ~Phone and ~Volume Down for 5 seconds.
3.
When the voice-assisted menu reaches your required option ("Language", "A2DP Audio Priority", "Spoken Status
Announcements", "Click-to-Link", "AGC", "RDS", "VOX Sensitivity", "VOX", "Background Audio Level "), tap ~ or use
VOX.
4.4
Checking Battery Status through Cardo SmartSet
Battery Status on Your Mobile Phone
If you installed SmartSet on your mobile phone, you can check the battery status as follows:
You can also use the left and right blue arrows on the frequency scale to update the preset frequency.
If your SMARTH is not in Bluetooth intercom mode, press ~Intercom and ~Audio. For more information see,
"Switching to Bluetooth Intercom" on page 31.
To Next Page
Loading...
Need help?
General
