Carestream CS 7200 - Page 71

CS 7200 User and Installation Guide (6M0940)_Ed04 67
LED indicator blinks red.
No error message is
displayed.
The cause is unknown.
 Restart the Scanner.
 If problem persists, call Service.
LED indicator blinks red
during the Scanner power on
and the noise is sounded.
Scanner hardware malfunction.
 Restart the Scanner.
 If the problem persists, repeat for three
times.
 If problem persists, call Service.
LED indicator is red.
Error code #9011
Scanner hardware malfunction.
 Restart the Scanner.
 If problem persists, call Service.
LED indicator blinks red
Error code #9012
Scanner hardware malfunction.
 Restart the Scanner.
 If problem persists, call Service.
LED indicator is red or off.
Error code #9014
Scanner hardware malfunction.
 Restart the Scanner.
 If problem persists, call Service.
LED indicator blinks red
Error code #9015
Insertion panel is detached from the
scanner.
 Properly attach the panel to the scanner.
Warning: Do not change the position of the
plate selector knob.
 Click OK to close the error message and
proceed.
LED indicator blinks red
Error code #9016
The plate was not scanned and
remained inside the scanner.
 Remove the insertion panel.
 While holding the visible part of the plate,
lift the scanner protection door.
 Remove the plate from the scanner.
 If the plate fell inside the scanner, remove
the service tray and remove the plate.
 Attach the insertion panel.
 Click OK to close the error message.
 Perform a scan.
LED indicator blinks red
Error code #9021, 9022,
9023
Scanner hardware malfunction.
 Restart the Scanner.
 If problem persists, call Service.
LED indicator blinks red
Error code #9024
 Scanner hardware malfunction.
 Power Supply malfunction.
 Restart the Scanner.
 Replace Scanner Power Supply.
 If problem persists, call Service.
LED indicator blinks red
Error code #9025
Scanner hardware malfunction.
 Turn off the scanner.
 Wait for five minutes and restart the
Scanner.
 If problem persists, call Service.
LED indicator blinks red
Error code #9030
Software files version does not match
the scanner files version.
Update scanner files.
LED indicator blinks red
Error code #9031
Scanner hardware malfunction.
 Click OK to shut down the scanner.
 Restart the scanner. The plate is ejected.
 Rescan the plate.
 If the problem persists, call Service.
LED indicator blinks red
Error code #9032, 9036
Scanner hardware malfunction.
 Click OK to eject the plate.
 Rescan the plate.
 If the problem persists, call Service.
LED indicator blinks red
Error code #9039
Scanner hardware malfunction.
 Restart the scanner.
 If the problem persists, call Service.
LED indicator blinks red
Error code #9043
 Plate was not loaded properly.
 Scanner hardware malfunction.
 Click OK to eject the plate.
 Rescan the plate.
 If the problem persists, restart the Scanner.
 If the problem persists, call Service.
Symptom Cause Corrective Action