4.19Disassembly and cleaning procedures
Insert the brush into
the Espresso group
and remove the res-
idues.
Rinse the Espresso
group thoroughly
using lukewarm wa-
ter and manually ro-
tate the gears.
ATTENTION
Make sure the components are perfectly dry before installing them
again on the machine, to prevent bacteria growth.
NOTE
Assemble the Espresso group by proceeding in the reverse order
compared to the above instructions.
Check:
• The gears are aligned properly.
• The group is inside its seat and all components are tight enough.
• The hydraulic circuit hoses are connected properly.
• The lower safety block was moved to the right in rest position.
Close the upper
front door.
To Next Page
Loading...
