62-61753-21
P208 CHK GENERATOR CONT CIRC
TRIGGER-ON: Normal amps for the GENCONR and GENCON coils are 0.0 to 1.0 Amps (12 VDC).
The circuit tests outside this range.
UNIT CONTROL: Engine and standby operation: Pretrip will fail and display "PRE-TRIP FAIL AND
COMPLETED".
RESET CONDITION: Auto Reset if Pretrip is started again, or alarm may be manually reset via key-
pad or by turning the unit off, then back on again.
NOTE: Follow the steps below until a problem is found. Once a repair or correction has been made, clear the
alarm(s). See Note 1 Page 7-1. Operate the unit through the appropriate modes to see if any active alarm occurs.
Continue with the steps below as necessary.
a. Inspect GENCONR and GENCON
contactor coils and wire connec-
tions.
No damage to coil.
No damaged or corroded pins.
b. Check contactor coil resistance.
Check GENCONR and GENCON Amp Draw
a. Check GENCONR and GENCON
contactor coils amp draw.
Use Component Test Mode (Section 5.1.2) to test.
Refer to Section 2.12 for amp values. View current
draw in Data List. FET 3 On.
b. Listen for GENCON to pull in.
If GENCON contactor pulls in, GENCONR and
GENCON are OK.
If GENCON contactor does not pull in, check for volt-
age at GENCON coil. 12 VDC indicates defective
GENCON coil. No voltage - check GENCONR.
a. Inspect harness & control box
connector pins & terminals. (See
wiring schematic Section 10.)
See Note 2 & Note 5 Page 7.2.
No physical damage to harness.
No damaged or corroded pins.
To Next Page
Loading...
