62-61753-21
2.12 ELECTRICAL DATA
System current limit - high speed: 16 amps
System current limit - low speed: 14.5 amps
0.83hp (610 watts) @ 65 Hz
310 to 660 VAC; 45 to 65 Hz
Factory lubricated, additional grease not required
Clockwise when viewed from shaft end
Resistance (cold) per rod
U-type heater 97.6 ohms ±5
One U-type heater & four straight heaters
Resistance (cold) per rod
U-type heater 187 ohms ±5
Resistance (cold) per rod
Straight heaters 93.5 ohms ±5
Resistance (cold) per rod
U-type heater 97.6 ohms ±5
0.66 hp (485 watts) @ 65hz
310 to 660 VAC 45 to 65 Hz
Factory lubricated, additional grease not required
Clockwise when viewed from inlet
0.58 ohms (phase to neutral)
16 KVA @ 0.82 p.f @ 1850 rpm
12 volt nominal - 90 amp hour capacity
Cold cranking amps = 425 DIN, 500 IEC, 725 BCI
Standby Power
Requirements