Carrier VECTOR 1550 Series - View Hourmeters

62-61753-21
3-20
3.14 VIEW HOURMETERS
COOL DEFROST ALARM START-STOP
ERUTAREPMETXOBTNIOPTES
ALARM LIST
SELECT
MANUAL
DEFROST
SUOUNITNOCTAEH
START--STOP/
CONTINUOUS
TOTAL ENGINE HOURS: 0 HRS
1. Press the SELECT key until the MessageCenter dis-
plays “PRESS ↑↓ TO VIEW HOUR METERS”.
2. Press the UP or DOWN ARROW key to move through
the Hour Meter List.
3. Displayed hour meters will depend on unit Configurations (refer to Section 5.1.1).
Typical displayed meters are: “TOTAL ENGINE HOURS”, “STANDBY RUN
HOURS” and “TOTAL SWITCH ON HOURS”.
4. Pressing the “=” key will access all other meters and display “OTHER METERS AND COUNT-
ERS”.
5. Selected hour meter will remain in the MessageCenter for 10 seconds, then the default message
(“STATUS OK” or other customer specified message) will display.
6. To lock an hour meter in the MessageCenter, press the “=” key. The Data item will flash
continuously to indicate it is locked.
7. Pressing any key on the keypad will unlock the item. Pressing the UP or DOWN AR-
ROW key will move to the next hour meter.
+34.5° F
--20.0
Hour meters available when "OTHER METERS AND COUNTERS" is chosen are:
 Meters listed in Step 3 above.
 Engine Protect Hours
 Switch On Protect Hours
 Switch On Standby Hours
 Engine Sleep Hours
 Switch On Sleep Hours
 High Speed Hours
 Start cycles
 Compressor Run Hours
 Maintenance Days
 And, up to 5 User Configurable meters