Carrier VECTOR 1550 Series - Downloading Data with the Pc Card

62-61753-21
5-4
5.2 DOWNLOADING DATA WITH THE PC CARD
COO L DEFROST ALARM START-STOP
SETPOINT BOX TEMPERATURE
ALARM LIST
SELECT
MANUAL
DEFROST
SUOUNITNOCTAEH
+36F
-20
COPYING DATA--PLEASE WAIT
2. Insert a Download Card into the PC card slot on
the front of the microprocessor. Be certain that
the instruction label is facing the “Caution” la-
bel. Do not force card into slot.
3. The MessageCenter will display “COPYING
DATA--PLEASE WAIT”. While the data is being
copied, the green PC CARD STATUS LED will
flash.
4. When the copy is complete, “COPY
COMPLETE, REMOVE CARD X” (“X” is the
number of empty spaces remaining on the card)
will show in the MessageCenter. The PC Card
Status LED will be solid. The PC card may then
be removed. Do not remove the card until
prompted to do so.
5. When the card is removed, the MessageCenter
will return to the default message.
6. If any other messages appear, refer to Section 6.1
MessageCenter for an explanation of the error
message. If there is an error, the PC CARD FAULT
LED will be on until the card is removed.
1 Place the Stop/Run -- Off Switch (SROS) switch in the
Start/Run Position.
7. Data must be uploaded off of the Download Card
ontoacomputer drive, using ReeferManager, before
it can be viewed.
START--STOP/
CONTINUOUS
CAUTION
2