Carrier VECTOR 1550 Series - SECTION 3 - OPERATION; STARTING UNIT - ENGINE OPERATION

62-61753-21
3-1
SECTION 3 -
OPERATION
WARNING
LogiCOLD microprocessor equipped units
may start automatically at any time the
START/RUN-OFF switch (SROS) is not in
the OFF position. Also, the unit may be fit-
ted with two way communication equip-
ment that will allow stating of the unit from
a remote location even though the SROS is
in the off position.
WARNING
Be aware of HIGH VOLTAGE supplied at
the power plug or from the generator.
When performing service or maintenance
procedures: ensure any two way commu-
nication is disabled in accordance with the
manufacturers instruction, ensure the
START/RUN-OFF switch is in the OFF posi-
tion and, whenever practical, disconnect
the high voltage source and disconnect the
negative battery connection. NEVER dis-
assemble the generator: HIGH MAGNETIC
FIELD INSIDE! This field can interfere with
cardiac implants such as pacemakers and
defibrillators.
3.1 STARTING UNIT - ENGINE OPERATION
WARNING
Under no circumstances should ether or any other starting aids be used to start engine.
2. Place the START / RUN - OFF switch
(SROS) in the START/RUN position.
STANDB Y
ENGINE
START/RUN
OFF
0
I
LANGUAGE
1. Place the STANDBY/ENGINE switch in
the ENGINE position
3. The microprocessor will then enter pretest,
perform preset (refer to section 3.3) and start
automatically.
+34.5° F--20.0
MODE LIGHTS
MAIN DISPLAY
MessageCenter
DOOR