Case CX75SR - Replacing the Fuel Filter; Filling the Fuel Tank

CHAPTER 5 - LUBRICATION, FILTERS, AND FLUIDS
5-30
Issued 8-04 Bur 6-34551NA
(
CT02D040
Figure 72
CX135SR
To access the filter, open the engine hood.
CT02D049
Figure 73
REPLACING THE FUEL FILTER
1. Clean the area around the filter head.
2. Place a receptacle of a suitable capacity under
the filter and remove the filter, using a filter
wrench.
3. Coat the seal of the new filter with a fine film of oil
or grease.
NOTE: Do not fill the new filter with fuel before
installing.
4. Install the new filter. Turn the filter until the seal
comes into contact with the filter head and turn
an extra half turn by hand.
IMPORTANT: Do not use a filter wrench to install
the filter. Overtightening the filter can damage
the seal and filter.
NOTE: If the engine does not regain full power after
replacing the filter, bleed the system.
CX75SR, CX80
CT02D042
Figure 74
CX135SR
CT02D044
Figure 75
FILLING THE FUEL TANK
1. Clean carefully around the filling cap.
2. Fill the tank, make sure that no water or dust
enters the tank.
IMPORTANT: Never remove the tank filter for filling.
IMPORTANT: In cold weather, use fuel
corresponding to the ambient temperature. See
Lubrication and fluids. Fill the fuel tank after each
working day to prevent the formation of
condensation.
3. Install the filler cap.
IMPORTANT: Make sure that the cap is correctly
locked.
WARNING: Completely wipe off any spilled
fuel. It may cause a fire.
WARNING: Completely wipe off any spilled
fuel. It may cause a fire.
WARNING: Never refuel when the engine is
running. Never smoke when refuelling.