78
SHOOTING A SNAPSHOT
■ Checking the Flash Mode
The current flash mode is indicated on the monitor screen and
by the operation lamp when you half-press the shutter button.
• You will not be able to take another flash snapshot until the
operating lamp stops flashing orange, which indicates that
charging is complete.
■ Changing the Flash Intensity
1. In a REC mode, press [MENU].
2. On the “Quality” tab, select “Flash Intensity”
and then press [X].
3. Use [S] and [T] to select the flash intensity
setting you want and then press [SET].
You can set one of five levels, from –2 (weakest) to +2
(strongest).
IMPORTANT!
• Flash intensity may not change when the subject is too far
away or too close.
5
“ ” indicates flash will fire.
Operation Lamp
Flashes orange while the flash is charging.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
