279
APPENDIX
If you have problems installing the USB driver...
You may not be able to install the USB driver properly if you use the USB cable to connect the camera to a computer running Windows
98SE/98 before installing the USB driver from the bundled CD-ROM, or if you have another type of driver installed.
This will make it impossible for the computer to recognize the camera when it is connected. If this happens, you will need to re-install the
camera’s USB driver.
For information about how to re-install the USB driver, see the USB driver’s “Read me” file on the CD-ROM that comes bundled with the
camera.
Display language setting
screen appears when the
camera is turned on.
1) You did not configure initial settings after purchasing the camera or the battery may have been left with
a dead battery. Check the camera setup (pages 11, 215).
2) The may be a problem with the camera’s built-in memory management area. If this is the case, perform
the reset operation to initialize the camera’s setup (page 159). After that, configure each setting. If the
language selection screen does not re-appear when you turn the camera on, it means that the camera’s
built-in memory management area has been restored.
If the same message appears after you turn power back on, contact your retailer or a CASIO service
center.
Problem Possible Causes and Action
To Next Page
Loading...
Need help?
General
Weight and Dimensions
