96
SHOOTING A SNAPSHOT
■ Using Edit Family to Assign a Priority Level
to Recorded Face Data
After recording face data, you can assign a name and a priority
level that controls how the data is applied when shooting a
snapshot.
1. Enter a REC mode.
2. Press [S] ( ) once.
3. Use [W] and [X] to
select “ Edit
Family” and then press
[SET].
This display the face data
editing screen.
4. Use [S], [T], [W], and [X] to select the face
data you want to edit, and then press [SET].
5. Use [W] and [X] to select a name, and then
press [T].
• You can select any one of 12 preset names to face data.
6. Use [W] and [X] to select the priority level you
want and then press [SET].
• You can select any one of four levels, from “ ”
(Lowest) to “ ” (Highest). Selecting “ ”
(Disabled) will disable face recognition.
To Next Page
Loading...
