Ceewa S1 - Step 8: Check Drone Working Condition

49
Step 8: Check Drone Working Condition
When should I bind Follow Module & Sports Watch?
1. Activate Follow Module Binding Mode
After Follow Module has been turned on, press Power button for five to six times to enter binding mode.
When Blue Light of Follow Module blinks 3 times at intervals of 0.5s, binding mode enables.
0.5s
0.5s
Turn on Drone and check the working condition of gimbal. Ensure whether or not the Yellow LEDs blink correctly.
3. How to know binding is OK?
2. Activate Remote Controller Binding Mode
① When pressing H Button, turn on Remote Controller. Red Status LED blinks.
② Binding between Drone and Remote Controller will auto begin.
Devices OK Symbol Instructions
Follow Module &
Remote Controller
When binding finishes, Red Light of RC
Status Indicator would not blink.
If binding fails, Red Light of RC Status
Indicator would not stop blinking. You need
to power cycle Drone and RC to bind again.
How to bind?
Devices OK Symbol Instructions
Drone & Remote
Controller
When binding finishes, Red Light of RC
Status Indicator would not blink.
If binding fails, Red Light of RC Status
Indicator would not stop blinking. You need
to power cycle Drone and RC to bind again.
① Turn on Follow Module and Remote Controller, and enter CEEWA APP.
② Enter Flight Interface of CEEWA APP, and wait for 60s. If Follow Module
icon is shown as like the left diagram, binding should be done.
③ If Follow Module icon is shown as (constantly on or blinking), you can
ignore this step.
How to pair Remote Controller and CEEWA APP?
Refer to Chapter IV. Remote Controller → Step 9. Turn on CEEWA APP &
Pair to Remote Controller