71
Tap each waypoint in the map to edit its altitude and velocity in the pop-up window. Also, delete this waypoint in this pop-up
window.
Tap the eraser icon ( ) to delete all the waypoints.
CEEWA APP:
Step 14: Go-Home
Step 13: Check Live Image
Go-Home brings the drone back to the latest recorded Home Point.
CEEWA Drone supports three kinds of Go-Home, including Smart Go-Home, Low-Battery Go-Home, and Failsafe Go-Home.
Before going-home, you should set Home Point through Sports Watch or CEEWA APP. Three are three kinds of Home Points, including
“Set Take-off Position as Home Point” ( ), “Set Module Position as Home Point”( ) and “Set Current Drone Position as Home
Point”( ).
If you have not set Home Point, Drone would return to Take-off position by default.
:
Set Take-off Position as Home Point
: Set Module Position as Home Point
: Set Current Drone Position as Home Point
Set Home Point
Refer to Chapter IV. Remote Controller Version: Check before Flight → Step 11: Check Image Transmission to get detailed methods
to check live image.
If you want to take photos during flight, please refer to 4K Camera User Manual and 1080P Camera User Manual. Switch to
Timelapse Mode and choose an appropriate time interval from 3sec, 5sec and 10sec. After taking-off, drone will keep taking
photos.
If you want to enable Go-Home, it is suggested to set Home Point at first. Otherwise, Drone will return to take-off position by
default.
Take “Set Drone Current Coordinate as the New Home Point” as an example.
How to deactivate?
Remote Controller:
Press P Button. When RC vibrates once P Button Status LED is constantly on, P Mode has been activated.
To Next Page
Loading...