Ceewa S1 - LED Indicators & Vibrations; Drone Status Leds; Follow Module Leds

77
VII. LED Indicators & Vibrations
1. Drone Status LEDs
Normal
*3
Yellow Lights Blink 3 times. Binding
*4
Yellow Lights Blink 4 times. Data Transmission is upgrading.
Yellow Lights Blink slowly. A Mode(Attitude Mode)
Green Lights Blink slowly. P Mode(Position Mode)
*20
Green Lights Blink 20 times. GPS is positioned.
Yellow Lights are on. Calibrate Compass: horizontally rotate Drone.
Green Lights are on. Calibrate Compass: vertically rotate Drone.
Errors
*2 Red Lights blink twice.
Drone Compass should be
calibrated. / Calibration fails.
Do compass calibration.
*3 Red Lights blink 3 times. GPS Connection Error Contact to dealers for repairment.
*4
Red Lights blink 4 times.
Accelerometer Initialization
Error
Power cycle the drone. If the error still exists,
please contact to dealers for repairment.
*5 Red Lights blink 5 times. Gimbal Communication Error
Check the gimbal 6P connection cable. If the
error still exists, please contact to dealers for
repairment.
*6 Red Lights blink 6 times. TF Card Error of Data Logger Contact to dealers for repairment.
*10 Red Lights blink ten times. Entering No-fly zone. Leave No-fly zone.
*2 Yellow Lights blink twice. Drone Data Transmission Error
Power cycle the drone. If the error still exists,
please contact to dealers for repairment.
Yellow Lights Blink quickly.
Disconnecting between Drone
and Remote Controller.
If the error still exists when Drone and
Remote Controller are close, please contact
to dealers for repairment.
2. Follow Module LEDs
Status LED
Blue Light is on. Follow Module has turned on.
Blue Light blinks once. Press Power Button once.
*3
Blue Light blinks three times. Binding.
Blue Light is on. Binding is OK.
Blue Light blinks slowly. Calibrate Compass: horizontally rotate Follow Module.
Blue Light blinks quickly. Calibrate Compass: vertically rotate Follow Module.
Power LED
Red Light is on. Charging
Red Light blinks twice, and then
Follow Module is turned off.
Low Battery