Ceragon Evolution IP-20LH - 8 Connecting the Power Cable

Evolution® IP-20LH Installation Guide
Ceragon Proprietary and Confidential Page 82 of 101
8. Connecting the Power Cable
Caution!
In a 1RU chassis, the Fans unit receives its power from the TCC. Therefore, to
avoid over temperature in the chassis, do not power up the 1RU unit unless both
the TCC and Fans unit are installed in the chassis.
Important! Before connecting the power supply to the PDC, you must
verify that the positive pole in the external power supply is
grounded!
1RU units can use a single-feed or dual-feed PDC. The power cable connector
is included with the PDC.
The following power cables are available for use with a 1RU IP-20LH unit:
Ceragon Part Number
Marketing Model
Marketing Description
WA-0567-0
CBL-PWR-OE-OE-16A-2.2m
Power cable Open-end/Open-end, 16A, 2.2m
WA-0568-0
CBL-PWR-OE-OE-16A-5m
Power cable Open-end/Open-end, 16A, 5m
2RU units use a single-feed PDC. The power cable connector is pre-attached to
the power cable.
The following power cables are available for a 2RU IP-20LH unit:
Ceragon Part Number
Marketing Model
Marketing Description
WA-0488-0
CBL-PWR-DType/OE-40A-2.2m
Power cable D-Type/Open-end, 40A, 2.2m
WA-0566-0
CBL-PWR-DType/OE-40A-5m
Power cable D-Type/Open-end, 40A, 5m