Evolution® IP-20LH Installation Guide
Ceragon Proprietary and Confidential Page 84 of 101
8.2 For a 1RU Chassis
1. Expose the wires of the power cable.
2. Loosen the top two screws on the connector.
3. Verify that the wiring is according to the correct polarity.
Correct Wiring on a 1RU Chassis
4. Insert the wires into the connector.
5. Secure the wires in the connector with the screws.
6. Plug the connector into the PDC and tighten the two screws on the sides of
the connector to secure the connector.
Connecting the Power Cable in a 2RU Chassis – Single-Feed PDC
To Next Page
Loading...