Cessna 177 SERIES Service Manual

2 34 5 2 5
B8
Detail A _ C
A
Detail B
( *** \~~~~ * \.\~~~~ - ^^^^'-'NOTE
-'~^ '
s
~ ^'-~ .- ~"-" s 2 -~ X \Lubricate dowel pins (7)
" .~ \ : ~~. : X* ~ -~ '~\~\ ~with Electro Moly No. 11
, \ , .- 'Gu "~\ \- (MIL-G-21164) grease upon
installation.
Remoe fets an inspect fu to-wing
Remove fillets and inspect fuselage-to-wing
attachment at each 100-hour inspection.
Check
dowl pin
retaining
hardware,
carry-'
;hru spar, and wing fittings throughly.
12
Beginning with Serial 17700369, Landing and Taxi Light
retainers (6) are replaced
with THRU 1970
MODELS 13
S1450-4H24-125 washers.
If there is damage to bushings in fittings (2)
and (5), notify factory before anticipating
replacement,
as
these are
critical
areas.
Beginning
with the
1970
model,
the
wing leading edge is
recontoured.
12
Wing stations, removal and instal-
lation of the wings remain the same. BEGINNING WITH 1970 MODELS
(Leading Edge and Tip Contour)
Beginning with the 1971 Models, the
landing and taxi
lights are located
in
the nose cowl.
1. Bolt
5. Wing Fitting 9. Flap
13. Position Light
2. Fuselage Fitting
6. Retainer 10. Aileron
Tab 14. Landing and Taxi Light
3. Washer
7. Dowl Pin
11. Aileron 15.
Stall Strip
4. Nut
8. Wing
12. Wing
Tip
16. Fairing
Figure 4-1. Wing Installation
Change 7 4-3

Cessna 177 SERIES Specifications

General

Manufacturer	Cessna
Engine Type	Piston
Wingspan	35 ft 6 in (10.82 m)
Seating Capacity	4
Number Built	4, 295
Engine	Lycoming O-360
Horsepower	180 hp
Maximum Takeoff Weight	2, 500 lb (1, 134 kg)