Edge MAXX Introduction
1-1
Chapter 1
INTRODUCTION
This chapter contains the following sections:
1.1 Warranty
1.2 Scope of Manual
1.3 Safety
1.4 Equipment Description
The Edge Maxx
®
automatic spreader/feeders allow operators to feed wet sheets or other large pieces
of flatwork into a flatwork ironer. Because operators do not need to locate and clip one or more corners
during loading, each operator can feed substantially more pieces per hour than using a traditional automatic
feeder. The unit has two operator stations for higher production rates.
Like the rest of the CHICAGO
®
product line, the Edge Maxx is designed, manufactured, and assembled
in Chicago, Illinois. Before the CHICAGO
®
nameplate is affixed to any machine, a final inspection is
performed, including thorough testing under load conditions.
Any questions concerning the installation, operation, or repair of the unit should be directed to a local
authorized CHICAGO
®
dealer or the Chicago Dryer Company factory Service Department at:
Chicago Dryer Company (773) 235-4430
2200 North Pulaski Fax (773) 235-4439
Chicago, Illinois USA 60639-3737 Email service@chidry.com
Figure 1-1: The Edge Maxx provides high quality spreading and feeding.
To Next Page
Loading...