Edge MAXX Preventive Maintenance
4-11
Check Belt and Ribbon Condition
and Tension
Perform only when the unit is
RUNNING.
Use extreme caution.
WARNING
Keep hands and loose
clothing away from any
moving parts of the machine.
Serious injury could result.
Check the inlet and side conveyor belts along
with the transfer conveyor, reject conveyor and
discharge conveyor ribbons for proper placement,
tracking, tension (no visual sagging) and general
condition (smoothness, fraying, and tears).
For belt and/or ribbon adjustment and
replacement instructions, refer to the REPAIR
chapter and the appropriate section and
procedure.
4.3 Monthly PM
(200 hours)
WARNING
Do not repair or correct any
of these conditions without
reading and understanding
the Repair chapter.
Only qualified personnel
should troubleshoot and
repair this unit.
Make sure the power is
turned OFF at the main
disconnect switch.
Follow lockout/tagout
procedures approved for
your site. Follow local
regulations. Failure to do so
could result in serious injury.
To Next Page
Loading...