Installation Edge MAXX
2-22
Checkout Completion
If any checkout step is unsuccessful, refer
to the TROUBLESHOOTING and REPAIR
chapters of this manual.
If a problem cannot be resolved, contact
your local CHICAGO
®
distributor or Chicago
Dryer Company’s factory customer service
department.
Cleaning the Unit
During shipment and installation of the
spreader/feeder, some dirt or other contaminants
may have accumulated that will mark processed
flatwork. With the power disconnected, wipe
down the unit.
Also, process several pieces of flatwork to
clear any dirt from the moving components.
CAUTION
Make sure to lubricate
the upper spreader rail
before initial use. For more
information, refer to the
PREVENTIVE MAINTENANCE
chapter, Weekly PM section,
Lubricate Upper Spreader
Rail procedure.
To Next Page
Loading...