Chicago Dryer Edge MAXX - Page 7

Edge MAXX Table of Contents
v
CHAPTER 4 PREVENTIVE MAINTENANCE
4.1 Daily PM (8 hours) ................................................................................... 4-2
Watch and Listen for Anything Abnormal ................................................ 4-2
General Cleanliness ................................................................................ 4-2
Check Safety Equipment ......................................................................... 4-3
4.2 Weekly PM (50 hours) ............................................................................. 4-3
Check and Clean Photosensors and Reflectors ..................................... 4-4
Check and Clean Inverters ...................................................................... 4-4
Check For String Accumulation ............................................................... 4-5
Check Pneumatic Clutch/Brake Roller Alignment ................................... 4-5
Lubricate Transfer and Upper Spreader Rails ......................................... 4-6
Check Transfer Clamp Assembly and Grooved Bearings ....................... 4-7
Inspect the Rodless Air Cylinders ........................................................... 4-7
Inspect Air Filter/Auto Drain .................................................................... 4-9
Check Air Pressure Settings ................................................................... 4-9
Check Belt and Ribbon Condition and Tension ......................................4-11
4.3 Monthly PM (200 hours) .........................................................................4-11
Check Setscrews................................................................................... 4-12
Check Spreader Clamp Linear Bearing Assemblies ............................. 4-12
Check Upper and Lower Spreader Belt Condition and Tension ............ 4-13
Check Transfer Belts Condition and Tension ........................................ 4-13
Inspect Drive Belt Condition .................................................................. 4-14
Clean and Lubricate Drive Chain .......................................................... 4-15
4.4 Semi-Annual PM (1000 hours) .............................................................. 4-15
Clean Air Filter/ Auto Drain .................................................................... 4-16
Check and Grease Bearings ................................................................. 4-17
Check and Grease Transfer Conveyor Gears ....................................... 4-19
4.5 Annual PM (2000 hours) ....................................................................... 4-19
Check All Electrical Connections ........................................................... 4-20
Check Insulation Resistance to Earth Ground ...................................... 4-20
TOC
INDEX