Chino DB650 - Page 21

[DB600] General Instruction Manual
- 19 -
Power terminal
100-240V AC Power
24V AC/DC Power
Measuring input terminal
Thermocouple/voltage
mV
Voltage V
Resistance
thermometer
*Do not wire except for specified terminals.
*For inputting current, connect shunt resistor (250Ω/selling separately) between ＋ and －.
Control output 1 terminal
ON-OFF pulse output
Current/SSR drive pulse/voltage
output
Control output 2/event output terminal (mechanical relay)
ON-OFF pulse output
Current/SSR drive pulse voltage
output
Event 1 output
Event output terminal (mechanical relay)
Event 2 output
Communication interface/external signal input/event output terminal (open corrector
output)
RS485 + remote signal input
1point
External signal input 5 point
Event output 5points