Control Setup Chore-Tronics® 3 Control
34
MT2398C
Feed Lines
1. Press the Feed Lines button. 2. Enter the board and input of each Feed Line
connected to the Control. Feed Line run times
will be generated from these inputs.
Water Pressure
1. Press the Water Pressure button. 2. Enter the board and input for the Water pres-
sure switch. Switch must open with low pressure.
The parameters are setup in the Alarm screen un-
der the Production tab.
Auger Run Time
1. Press the Auger Run Time button.
2. Enter the board and input of the Auger run time
relay. The parameters are setup in the Alarm
screen under the Production tab.
To Next Page
Loading...