If continuing to setup Ceiling Inlets from the Sidewall screen above, select the Back button
twice to return to the Setup/Outputs/Curtain Screen.
1. Select the Main menu button. 2. Select the Setup button.
3. Select the Outputs button. 4. Select the Ceiling Inlet button.
5. In the Setup/Outputs/Curtain/Ceiling
Inlet screen select the relays that are to
be assigned to the Ceiling inlets. Select
the Open relay from the drop down and
the Close relay will be assigned by the
control. Only two sets of (Open/Close)
relays can be assigned. External relays
must be used if more than two ma-
chines are installed. Both sets of relays
are operated at the same time.
Continue Setup of the Attic Inlet by
selecting the Control Tab...
6. Use Attic Air Sensors- Choose the
inside sensor (s) you want to use as
controlling sensors.
7. Inlet Anticipation- Select from the
drop down Calculated or Fixed.
8. Controlled By- Select from the
dropdown SP (Controlled by static
pressure or Gravity) If Gravity is se-
lected the Inlet anticipation Fix or
Calculated will have no effect.
9. Allow Attic Air From- Enter the
time of day you want to use the attic
air to ventilate. In the example to
the right; Attic air can be used from 8:00am until 5:00pm.
To Next Page
Loading...